How can I manually configure a SIP device?

Created by Sagecom Support, Modified on Sun, 06 Aug 2023 at 01:34 PM by Sagecom Support

You need to specify the Account ID value as the username, Service Password - as the password, and our SIP server IP address as the SIP Proxy address. The Outbound Proxy should be blank.

It is highly recommended to enable STUN (you can use any public service or our and put G729 and G711(PCMU) codecs to the top of the codec list.

Please make sure you disabled "Subscribe to MWI" (or similar option), since MWI notifications are delivered differently from the switch, and this option enabled may produce unwanted load on the phones.

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select atleast one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article